Se Habla Espanol
New Era Thumb Stabilizer

New Era Thumb Stabilizer


New Era Thumb Stabilizer HCPCS: L3924


Product Description

The New Thumb Stabilizer L3924 is a very effective brace for providing relief for your thumb and thumb joint after injury. It is also used to support the thumb joint in CWC osteoarthritis. The brace can be easily custom fitted by adjusting the flexible metal splint to ensure the correct position for your thumb joint. The L3924 thumb stabilizer allows for movement of the rest of the hand and arm while keeping the whole thumb fully supported. It has various benefits besides being durable and resistant to abrasions. It covers minimal surface of your hand and can be worn under a glove or underwater, and comes in sizes S-XL. Remove daily to allow your skin to breathe and washing of the brace.

Wrist Brace Sizing Guide
measure wrist

Step 1: Place end of tape measure at the wrist joint and measure approximately 5 inches up the wrist and mark the point.

measure circumference

Step 2: Measure the circumference at the 5″ mark, making sure the tape is neither too tight nor too loose. This is the Forearm Circumference.

measure circumference of wrist joint

Step 3: Measure the circumference at the wrist joint. For some off-the-shelf wrist splints, this Wrist Circumference measurement will be all you need.

measure circumference of knuckles

Step 4: Measure the circumference around the high points of the knuckles between your index and pinkie fingers (this is the MCP Circumference or the Palm Circumference).


Step 5: Use the measurements above and refer to the chart below to find the right wrist support for you.
Size Wrist Circumference Palm Circumference Forearm
S 6.5″-7.25″ Upto 8″ Upto 8″
M 7.25″-8″ Upto 8.5″ Upto 8.5″
L 8″-9″ 9″- 9.5″ Upto 9.5″
XL 9″-10″ 8.5″-9.5″ 8.5″-9.5″

Disclaimer: This guide is only for reference and does not factor in personal preferences or differences due to design

Additional Information

Weight 0.2 lbs


There are no reviews yet.

Leave a Reply

Your email address will not be published. Required fields are marked *